|
Usuarios conectados
Actualmente hay 5959 visitantes y 21 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Inserting the ink tanks
1. Unpack the ink tanks from their protective wrapping and slowly remove the tape.
Caution:
· To keep good print head quality, keep all the ink tanks
installed to the corresponding print head.
7. LOADING PAPER
Follow the steps below to load paper into the paper tray or bypass tray. You can load plain paper and other special paper. For detailed information of paper type, see page 2 � 2. Caution:
· Hold the tank upright when removing the tape. Do not
touch the uncovered opening on the ink tank, as ink will get on your hands.
LOADING PAPER INTO THE PAPER TRAY
1. Remove the output tray , and open the front lid of paper tray .
· Ensure that there are no pieces of tape remaining on
the ink tank. 2. Turn the ink tanks upside down, and then immediately insert each of them to the print head of corresponding number.
Match the ink tank number to the print head number.
Make sure that each tab securely fixes the ink tank by pressing here.
2. Adjust the guides and shown in the illustration to a little wider than the width of the paper.
Properly align the tab when inserting.
3. Load the paper.
Do not touch this portion. The printer may not print if it is dirty.
Load the paper print side down into the paper tray. Make sure to push the paper to the right side and the back side of the tray.
Caution:
· Ensure the number on the print head correspond to the
number on the ink tank.
3. Close the front cover.
4. Align the edge of the paper with guides
and
.
After closing the cover the carriage will return to its home position, and the ink will be fed to the print head (this could take a while). 4. Confirm the ink lamp is not blinking. When loading cards Set guide cards. up, and then fit guide and against the loaded
If the ink lamp continues to blink, open the front cover, return to step 5 of "Installing the Print Head" and follow the procedures once more.
|
|
|
> |
|