The VCR is fitted with its own tuner (just like a normal TV) and can be preset to receive up to 181 TV broadcast stations.
IN RF
VIDEO L AUDIO R
1
OUT
Plug in Auto Tuning
Auto Tuning searches for TV stations from VHF minimum to UHF maximum and memorizes every tuned program position. Notes: � If the VCR is turned on with the antenna not connected, all channels are skipped. � When Auto Tuning is canceled halfway, Auto Tuning is not executed even if the VCR is turned off and then turned on again. In this case, see page 13 �To Restart Plug in Auto Tuning�. 1 Press [POWER �/I (VCR �)] to turn on the TV and VCR after connecting the antenna cable and the AC power cord, Auto Tuning starts. Channel being searched
3
TV � AV
VOLUME
r s
W X
1
VCR �
INPUT SELECT VCR/TV
2
W X
REC
Â¥
OSD/DISPLAY RESET PICTURE MODE MENU
AUDIO
INDEX
: 9
3
NAVI
1
2
6
OK �
5
1
;/D PROG/CHECK CANCEL
4
SEARCH SPEED TIMER �
W X
1
2
3
4
r
DATE
r
ON
r
OFF
2
AUTO CHANNEL SET PROCEEDING
END : MENU
s
s
s
The VCR supplies a signal to the TV via the RF coaxial cable on channel US3 or 4. It is possible to view the video picture on your TV in the same way that you watch TV broadcasts. If you have connected the VCR to the TV through the video and audio input sockets, then you do not need to follow the procedure below. When the VCR is turned on after unpacking and connecting the antenna cable and the AC power cord, Plug in Auto Tuning starts automatically.
� Auto Tuning will stop halfway by turning the VCR off, pressing [MENU], playback or a power failure during Auto Tuning. � When there are 5 more CATV channels, the antenna system CATV is automatically selected; when there are 4 or fewer CATV channels, the TV is selected. If a change is required, conduct the resetting procedure described in step 4 on page 14. 2 Press [VCR/TV] to select the VCR mode.
