INSTALLATION INSTALLATION
WARNING: Turn off and disconnect the unit before working.
1
(1) Open the grille (Fig.1) by gently pulling the arrow marked portion. Remove the air filter (Fig.2) from the front panel. Unscrew the screw fixing the front panel to the chassis. (Fig.2) Keep the screw as it will be used later.
Grille
Fig.1 Air filter
2
1
Front panel Fig.2
CAUTION: Do not open the grille extremely wide, or provide stress to the opened grille. The grille may come off, or the grille shaft may get damaged. If the grille should come off, it can be replaced. Fit one of the grille shaft into the matching hole on the front panel, curve the grille slightly and fit in the other grille shaft.
Hole
Grille shaft Front panel
2
(2) Close the grille firmly, and remove the front panel by pulling the front panel at the lower corners towards you for about 3 cm (1" ). Then lift it up and pull it towards you. (Fig.3)
Fig.3 Front panel
1
2
(1) Unscrew the 3 stopper screws of the cabinet (Fig.4). Keep the front screw and the angle as they will be used later in step 5. (2) Slide the chassis out from the cabinet by pulling on the hand hold located at the bottom center of the chassis. (Fig.4)
