|
|
|
Usuarios conectados
Actualmente hay 5828 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
42012aGB.fm5 Page 2 Thursday, February 3, 2000 3:49 PM
PRODUCT SHEET
Switching on the freezer for the first time
� � � � It is advisable to set the thermostat to a middle position on the thermostat scale (factory set position). Plug in the appliance. The green LED will illuminate. The red LED will also light up since the temperature inside the freezer is not yet sufficiently low for food storage. The red LED will normally switch off within the first six hours after the appliance is switched on. Only place food inside the freezer once the red LED has switched off. It will prove difficult to open the lid immediately after closing it because the hermetic seal means there is a partial vacuum inside the freezer. Wait a few minutes before re-opening the lid.
� �
After connecting the appliance to the mains, once the right temperature has been reached (about an hour), ensure that the fast freeze function is inactive (yellow LED is off).
Freezer compartment temperature adjustment
To adjust the compartment temperature, proceed as follows: � Turn the thermostat knob x to position 1 to set the highest (least cold) storage temperature. � Turn the thermostat knob x to position 6 / to set the lowest (coldest) storage temperature. � When the freezer is only partially filled, it is advisable to set the thermostat to lower positions (towards position �E�, if indicated on the thermostat scale).
Energy saving tips
� � � � � � � Do not install the appliance in places exposed to direct sunlight or near heat sources. Do not obstruct the ventilation grille or the air circulation openings. Remove accumulated dust from the rear of the appliance at least once a year. Use the thermostat to select the ideal storage temperature. Never place hot foods in the freezer. Restrict the number of times you open the lid. Make sure the ice layer does not build up to more than 5-6 mm thick.
Changing the lid light bulb
� � � � Unplug the appliance. Remove the diffuser by following the sequence of steps shown in the figure. Unscrew the light bulb and replace it with an identical bulb of the same wattage and voltage. Refit the diffuser and plug in the appliance.
1 2
3
5019 100 42012/A
PL
CZ
SK
H
RUS
BG
RO
GB
Printed in Italy
12/99
|
|
|
> |
|
