WHIRLPOOL AFG 070NF AP
Guía de consulta rápida

GB

INSTRUCTIONS FOR USE
� � 4. The green LED (if provided) off and the appliance is Do not eat cubes or ice lollies immediately after taking appliance walls. help prevent potential negative consequences for the

PRECAUTIONS AND GENERAL � Place a bowl beneath 3. The green LED (if provided) off and the appliance is 2. Scrapping

drainage channel to collect the RECOMMENDATIONS not working. The appliance is manufactured using recyclable material .

� After installation, make sure that not residual water. If available, use � Is there a power failure? This appliance is marked according to the European directive

Do not store glass containers with liquids in the appliance � Speed up defrosting by using a (WEEE). Is the electric cable intact?

standing power supply cable. the divider. 2002/96/EC on Waste Electrical and Electronic Equipment � Is plug properly inserted in the socket?

since they may burst. spatula to detach the ice from By ensuring this product is disposed of correctly, you will

Before servicing or cleaning appliance, unplug it from appliance. � The green LED is not working. Contact the After Sales caused by inappropriate waste handling of this product.

them out of appliance since they may cause cold burns. working. � Remove ice from the bottom environment and human health, which could otherwise be

mains or disconnect electrical power supply. � In order avoid permanent damage to the appliance Service for a replacement. accompanying the product, indicates that this appliance may not treated as household waste. Instead it shall be handed power consumption. Has appliance lid been left open a long time? over to applicable collection point for the recycling of Do not store use gasoline or other flammable vapours � � and liquids vicinity of this any other appliance. The � Is the appliance placed in a very warm room or near heat The symbol product, or on the documents � Do not install the appliance in places exposed to direct interior, do not use pointed or sharp metal sunlight or near heat sources in order to avoid increasing instruments for removing the ice. Do not use abrasive products or heat up the interior

5. The compressor runs continuously.

�

� Have hot foods been put in the appliance?

artificially.

Install appliance in perfectly horizontal position, on a floor � Is the thermostat setting correct? environmental regulations for waste disposal. Deliver the Disposal must be carried out in accordance with local size and use. � Remove ice from upper edge (see the Install the appliance in a dry and well-ventilated place. Troubleshooting Guide). �

� Dry interior of the appliance thoroughly. � fumes can create a fire hazard or explosion. sources? On completion of defrosting, refit the plug.

electrical and electronic equipment.

Before scrapping, make the appliance unusable by cutting off power cable removing the doors and shelves so that

strong enough to take weight and in an area suitable for its CARE AND MAINTENANCE children cannot easily climb inside the appliance. � Has the fast freeze function (depending on model) been pressed by mistake? 6. Too much ice on the upper edge. immediately to an authorized dump; do not leave it The appliance is set for operation at specific ambient � Clean the inside after defrosting, using a sponge dampened Are defrost water drainage plugs correctly positioned? unattended even for a few days, since it is temperature ranges, according to the climatic class indicated with warm water and/or mild detergent. �

� If appliance left empty for short periods, it is waste disposal service or shop where you purchased the Before carrying out maintenance, unplug appliance. � Have the 4 protection pieces been removed? (See chapter

data plate located at rear of product. The Clean side motor cooling grille (depending on model). � Is the appliance lid properly closed? potentiallydangerous for children. For more detailed may not work properly if it is left for a long period Is appliance lid seal damaged or deformed? (See chapter information about treatment, recovery and recycling of this Remove dust from condenser on rear of the � at a temperature above or below the indicated range. product, please contact local city office, your household appliance. �Installation�)

� Information:

preferable not to switch it off. product. Do not use abrasive products, scourers or �Installation�) This appliance does not contain CFCs (replaced with R134a) or HFCs (replaced with R600a).

� Do not use electrical appliances inside the product, unless CHANGING THE LID appliance located in a damp or poorly ventilated room. Caution required, however, since isobutane is flammable. � This appliance is not designed for use by young children or

Be careful not to damage floors when you move the 7. Formation condensate on external walls of the appliance (e.g. parquet flooring). appliance. Do not use mechanical devices or any means other than � To obtain the best results from your appliance, carry those recommended by manufacturer speed up the It is normal for condensation to form under certain Appliances with Isobutane (R600a): � out cleaning and maintenance at least once a year. defrosting process. atmospheric conditions (humidity above 85%) or if the Isobutane is a natural gas with low environmental impact.

stain-removers (e.g. acetone, trichloroethylene) to clean the appliance.

such appliances are specifically recommended by the LIGHT BULB Therefore, it is essential to ensure that refrigerant pipelines The performance of the appliance is in no way affected. manufacturer. are not damaged. (IF PROVIDED)

� Disconnect the appliance from Declaration of conformity

To avoid the risk of children being trapped and therefore � This phenomenon is quite normal. � Remove the diffuser by manufactured in conformity with European Directive
� The power cable may only be replaced by an authorized � Thisappliance is designed, manufactured, and retailed in

the infirm without supervision. the mains power supply. � This appliance designed to store food and is

8. The layer ice on internal walls of the appliance is not uniform.

suffocating, do not allow them to play or hide inside the following the sequence of steps SAFEGUARDING THE ENVIRONMENT 90/128/EEC, 02/72/EEC and Regulation (EC) appliance. shown in the figure. No. 1935/2004

Unscrew the light bulb and

1. Packing

� The packaging material is entirely recyclable, and marked with person.

compliance with:

� Ensure that voltage indicated on appliance data 1. The red LED (if provided) remains alight. protection requirements of the "EMC" Directive

safety objectives of the Low Voltage Directive switch located upline from the socket. 73/23/EEC; TROUBLESHOOTING GUIDE

� unplugging the appliance or by means of a double-pole etc.) out reach of children, as they are potentially dangerous.

replace it with an identical bulb of the same wattage and the recycling symbol. Follow local regulations for scrapping. Do not use extension leads or adapters. Electrical disconnection must be possible either by Keep the packaging materials (plastic bags, polystyrene parts, �

voltage. Refit diffuser and plug in the appliance.

� Do not ingest contents (non-toxic) ice packs The electrical safety of the appliance can only be � Is a defrosting operation in progress?

plate corresponds to the domestic supply voltage. � Is there a power failure? 89/336/EEC amended by Directive 93/68/EEC.

� Restrict number of times you open the lid. � Is the appliance placed near a heat source? earth connection.

(if provided). � Is appliance lid properly closed? guaranteed if the product is connected to an approved

DEFROSTING THE APPLIANCE � Is the thermostat setting correct? AFTER-SALES SERVICE Specify: on the walls reaches 5-6 mm. 2. The appliance is too noisy.
Before contacting After-Sales Service: � nature of the fault, � Disconnect appliance from the mains power supply. � Is the appliance perfectly horizontal?

� Are ventilation grille and condenser clean? The appliance should be defrosted when the thickness of ice

Remove packs of food from appliance and wrap them 1. See if you can solve problem yourself. � the model, � Is the appliance in contact with other furniture or objects

� Leave the appliance lid open. Note: Gurgling noises from refrigerating circuit after the � your full address,

close together newspaper and store in a very cool place or � service (the number after the word SERVICE that may cause vibrations? 2. Switch appliance on again to see if the problem has thermally insulated bag. Has packaging removed under appliance? rating plate on rear of the appliance) been solved. If it has not, disconnect the appliance from �
� Remove the internal defrost water drain plug (depending 3. If the problem persists after this course of action, contact � Remove the external defrost

compressor cuts out are perfectly normal. � your telephone number and area code.

on model).

the power supply and wait for about an hour before switching on again.

After-Sales Service. water drain plug (depending on

model) and reposition it as shown in the figure.