SHARP AE-X13BE
Manual de Servicio

AY-XP08/10/13CE AE-X08/10BE-C AE-X13BE

CN101 and CN102

How to remove the horizontal louver Slightly pull down the hinge area, deflect the louver, and unhook it from the hinge. Remove the shaft from each of the left and right sides.

5. Remove 2 connectors. How to remove the HI VOLTAGE UNIT. 1. Remove the HIGH VOLTAGE UNIT.

6. Pull the board. Drain pan and related (Press and spread the hook, and HI VOLTAGE will be ready for removal.) How to remove the DUST SENSOR, the THERMISTOR and the GAS SENSOR. Remove the DUST SENSOR, the THERMISTOR, and the GAS SENSOR.
DUST SENSOR GAS SENSOR

1. Remove 3 screws fixing motors.

Drain Hose

THERMISTOR

Drain pan Groove

Projection
(Press and spread the hook,and GAS SENSOR will be ready for removal) How to remove the display board unit 2. The display board unit 2 is pushed in the direction of arrow 1 . And it is made to slide in the direction of arrow 2 , and remove.
1 2

To disconned

To reconnect

2. Turn the cap area of the drain hose counterclockwise, and remove it from the drain pan. During installation, turn the drain hose to the state of the �engagement position�. After reinstallation, verify that it is securely fastened.

display board unit2

38