Operating sequence
Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.
Turn the dial to the required setting.
50°
30° 40°
1. Place the laundry in the drum
Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door.
R0032S1
5. Select the option push button/s 6. Select the programme and start the machine
Turn the programme selector dial clockwise to the required programme. Before pulling the On/off programme selector check if: � The door is properly closed. � The appliance is plugged in. � The water supply tap is turned on. � The diaphragm lid is correctly screwed into place. � The drain hose is adequately positioned. Pull the program dial up to you till it klicks. The pilot light comes on and the program will begin.
P0004
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out the prewash, pour detergent into the appropriate compartment marked .
3. Measure out the additives
If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark.
R0033A R0033 B