WHIRLPOOL ACP602XM0
Manual de Usuario

14 Insert

Do not push against sharp fins and plastic parts. Attach green ground wire to the left-front corner of unit base by using retaining screw. (CAUTION: KEEP WIRE CONNECTED WHENEVER AIR CONDITIONER IS IN CABINET. IT IS THERE FOR YOUR ELECTRICAL SAFETY DURING OPERATION AND MAINTENANCE.)

air conditioner

into cabinet.

12 Install

window

seal

and window

lock bracket.

Press foam window seal into place and cut to proper length. Install lock bracket using wood screws. Made a 3�32� pilot hole first. (CAUTION: WINDOW LOCK BRACKET MUST BE INSTALLED AT ALL TIMES TO BE SURE AIR CONDITIONER DOES NOT FALL OUT OF WINDOW. REMOVE BRACKET ONLY WHEN YOU WISH TO REMOVE AIR CONDITIONER FROM WINDOW.) Seal small openings around installation with gum-type sealer.

15 Attach
pushing

front by placing
top down, then

bottom

edge

on clips

and

in and up.

13 Install

plastic

drain-cup

spout into hole at rear of

cabinet. Spout should be facing downward through hole. OPTIONAL: During high humidity, [condensate may drip from the outside of your air .zonditioner onto the ground below. If your atr czonditioner is installed where this is undesirable. �JOU can direct the water to a more suitable spot by simply attaching a 5/s�-inside-diameter, thinwalled hose to the drain spout at rear of cabinet.

14