WHIRLPOOL ACM122XR0
Manual de Usuario

4. Attach window-lock bracket to window sash with #8 x ³��" round-head screw to secure window in place.

WARNING

A B

A. Upper window sash B. Window-lock bracket

Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock.
5. Plug into a grounded 3 prong outlet. 6. Press RESET on the power supply cord plug.

AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the best possible results. This section explains proper air conditioner operation. IMPORTANT:
s

NOTE: The Exhaust control will function only when the Fan is operating.

Fan
Set the Fan control to the desired setting. When the air conditioner is operating at Low Cool, High Cool, or Turbo Cool, the fan circulates air continuously.
s s s s

If you turn off the air conditioner, wait at least 3 minutes before turning it back on. This prevents the air conditioner from blowing a fuse or tripping a circuit breaker. Do not try to operate your air conditioner in the cooling mode when outside temperature is below 65°F (18°C). The inside evaporator coil will freeze up, and the air conditioner will not operate properly.

s

Turbo Cool�for maximum cooling High Cool�for normal cooling Low Cool�for sleeping comfort Fan Only�fan will run continuously to move air, but the air will not be cooled. NOTE: Fan runs on Turbo speed only. Power Saver (on some models)�The fan runs only when cooling is needed. Since the fan does not circulate the room air continuously, less energy is used but the room air is not circulated as often. Use Power Saver when you are asleep or away from home. NOTE: Fan runs on Low speed only.

Starting Your Air Conditioner
1. Remove the clear, protective film from the front panel badge (on some models). 2. Set the exhaust control. See �Exhaust (on some models).� 3. Set fan speed. See �Fan.� 4. Select the temperature. See �Thermostat.�
s

Exhaust (on some models)
Set the Exhaust control to CLOSED for maximum continuous cooling. The Exhaust control set to OPEN position allows you to draw stale or smoky air from the room. s Open�to exhaust room air to the outside
s

Your air conditioner will have one of these fan controls:

Closed�to circulate room air
CLOSED

OPEN

7