System Connections
ENGLISH
� Please be certain that this unit is unplugged from the AC outlet before making any connections. � Be sure to observe the color coding when connecting the pre amplifier and speakers to this unit. � Make connections firmly and correctly. If not, poor connections can cause loss of sound, noise or damage to the unit. � For connections between this unit and the Sherwood compatible pre amplifier such as P-965, refer to the system connections in the operating instructions of that. Notes: � Do not place other equipment on top of this unit so that the radiated heat can be properly dispersed. � When installing in racks, etc., leave more than 30 cm(12�) of space at the top.
SER. NO.
MODEL NO. A-965
7-CH POWER AMPLIFIER
MADE IN KOREA DESIGNED IN USA
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT
FRONT RIGHT (4-8 )
SURROUND BACK RIGHT (4-8 )
SURROUND RIGHT(4-8 )
CENTER(4-8
)
SURROUND LEFT(4-8 )
SURROUND BACK LEFT (4-8 )
FRONT LEFT(4-8
)
1. DC TRIGGER IN
In case that this unit is connected to Sherwood pre amplifier P-965, connect this jack to the �1� jack of DC TRIGGER OUTs of P-965 directly for system power control. (For details, refer to the operating instructions of P-965.) Note: � When making DC TRIGGER connection, you should use the stereo mini cord supplied with this unit, not a mono mini cord.
Sherwood pre amplifier P-965
1 2
DC TRIGGER OUT
2. GROUND TERMINAL
If necessary, connect this terminal to the �GND� of other component.
3. AC INLET
Plug the supplied AC input cord into this AC INLET and then into the wall AC outlet. Note: � Do not use an AC input cord other than the one supplied with this unit. The AC input cord supplied is designed for use with this unit and should not be used with any other device.
