|
Usuarios conectados
Actualmente hay 5770 visitantes y 1 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
USING YOUR COOKTOP
COOKTOP SURFACE BURNERS LIGHTING SURFACE
BURNERS
1. Place utensilonburnergrate. 2. Push in and turn knob to the LITE position. To remove cooktop: When cool, first ¥0_!!:_tu_e_e_ remove grates and drip bowls, if equipped. Grasp two front burner wells and lift up.
I
Follow the instructions to the illustration that matches the burnerson your range. __
I
_E___._.
.:. '_ _I i
either a shippingscrew or a spring clip. be removed to allow quick and easy removal of the burner. One piece uniburner Once in place during transportationwith cured the range is installed, these seUniburners and single burners aremay 3. After the burner lights, turn knob to the desired flame size. , _' As the burner heats and cools, you may hearsounds of the metalexpanding and contracting. burner. sound of theThis is a normal operating
The top can be completely removed or, ifequipped with a metal support rod, can across the front of the burner box. rest on the red. Support rod is located
__"-_C,\
BURNER GRATES
Burner grates must be properly positioned before cooking. Do not operate porcelain finish may chip the grate. pan burners without a pan on without a The to absorb the intense heat. When reinstalling square grates, place indented sides together so straight sides are at front and rear. Allow burner to cool. Lift cooktop. To remove uniburner, lift up slightly and pull out. Under no circumstances are burners to be taken apart for cleaning. Uniburner can be cleaned in the dishwasher.Burnerandburnertubemustbe dry before use. Standard single burner
If flame should go out during a cooking operation, turn the burner off. IF GAS HAS ACCUMULATED AND A STRONG GAS ODOR IS DETECTED, WAIT 5 MINUTES FOR THE GAS ODOR TO DISAPPEAR BEFORE RELIGHTING BURNER. You may hear a "popping" sound on LP gas when the surface burner is turned
A properly adjusted burner with clean ports will light within a few seconds. On deeper blue inner core; there should be no trace of yellow in the flame. A yellow flame gas, the an improper mixture a naturalindicates flame will be blue withof theOff'Thisisan°rmaloperatingseundOfburner. air/gas. This wastes fuel, so have a serviceman adjust the mixture if a yelIowflame occurs. On LP gas, someyellow tipping is acceptable. This is normal and adjustment is not necessary.
I
_
1
[
_
Remove or support cooktop. Grasp burner head and tilt to release tab from slot near ignitor. Lift up and toward back of cooktop until air shutter end of burner releases from valve.
--8--
|
|
|
> |
|