Removing the Back Housing
1. 2. Remove the battery door, battery, and SIM card as described in the procedures. Using a Torx driver with a T-8 bit, remove the four screws from the bottom housing (see Figure 9A).
A
B
000961-A
Figure 9. Removing the Back Housing 3. With the screws removed, lift the back housing straight up to remove (see Figure 9B).
Replacing the Back Housing
1. 2. 3. 4. Align the back housing with the front housing (see Figure 9B). Press the back and front housings together. Replace the screws and tighten to 3.6 in-lbs +/- .2 in-lbs. Replace the SIM card, battery, and battery door as described in the procedures.
G
6881037B20
Do not over-tighten screws. Tighten screws to 3.6 in-lbs +/- .2 in-lbs.
