FEATURE MENU CONTROLS (CONTINUED)
ADD/DELETE CHANNELS
A
uto-Programming (see previous page) adds all the channels it can find (on your Antenna or Cable TV system) into the TV's memory. Add/Delete Channels makes it easy for you to add other channels, or drop unwanted channels, from the list of channels in the TV's memory.
BEGIN
MAIN MENU PICTURE FEATURES 1ST TIME SETUP SOUND HELP EXIT
1
Select CHANNEL MEMORY (ADD/DELETE CHANNELS) control. With the FEATURES MENU on screen, move the RED highlight with the MENU (M) buttons. Then press the MENU button.
FEATURE MENU PICTURE SOURCE CLOSED CAPTIONS EXIT CABLE TUNING CHANNEL MEMORY MORE... 1 OF 5
4
2
Press the CHANNEL vw or number buttons to select the channel you want to add or delete.
1
CLEAR
REC�
PLAY
MENU
STATUS
REW MUTE
M
FF PAUSE II SURF
3
Press the MENU button to ADD the channel into the TV's memory. Press the MENU button to DELETE the channel from memory. Repeat steps 2 and 3 for each channel you wish to add or delete.
CHANNEL MEMORY
STOP s
3
1
VOL CH ON/OFF POS SWAP FREEZE SIZE 2 TUNER PIP A B
ADD/DELETE CHANNELS START AUTO-PROGRAMMING EXIT HELP
2
1 4 7
2 5 8 0
3 6 9
TV /VCR SLEEP
ENTER
4
Press the STATUS or MENU button to clear the screen when through.
STOP
SMART POWER VCR M
ACC TV O D E
ADD/DELETE CHANNEL Channel 19 Added for ANT A SELECT CHANNEL to DELETE CHANNEL
AB
for ANT B when FINISHED
SMART HELP
Remember. You can also add the AUX 1 VIDEO, AUX 2 VIDEO, AUX 1 Y PB PR, or SIDE VIDEO modes just like a channel. Then by pressing the CHANNEL vw buttons the AUX(iliary) mode can quickly be selected to use the desired set of Input jacks (see page 33). Note: AUX(iliary) VIDEO modes are located between the lowest and highest channel numbers within the ADD/DELETE CHANNEL control screen.
M
NOTE: A separate ADD/DELETE CHANNEL memory may also be created for the ANT(enna) B Input on the rear of the set (if an Antenna or Cable TV signal has been connected). Just press the A button on the remote, B while in the ADD/DELETE CHANNEL mode, to switch between the ANT A and ANT B channel memory lists. Then follow steps 2 and 3 as shown to the left to add or delete the desired channels.
