PHILIPS 8P6034C
Manual de Usuario

SETTING YOUR REMOTE TO WORK VCRS, CONVERTERS - SEARCH

Y

our TV remote can be set to work your VCR or Cable Converter by what is called the SEARCH method. If the "REMOTE CODE" number method shown in the previous section did not set your remote to work your VCR or Converter, then follow the easy steps listed below. Please read through steps 1-4 before beginning.

CABLE CONVERTER

06

1
06

07 07

08

09
08

1

BEGIN

Press the POWER button on the VCR or Converter to turn the unit ON. Stand at least six feet away from the front of the VCR or Converter. Point the remote toward the unit. HOLD DOWN the SURF and the desired System (VCR or CBL-Converter) buttons at the same time. KEEP HOLDING BUTTONS DOWN.

VCR

09
Six Feet
(minimum)

2

Don't let the VCR or Converter scan up more than five channels (in Search mode).

3
REC q CLEAR PLAY
MENU

STATUS

REW

M

FF

24

3

Watch the Channel Indicator on the unit. Channel Numbers will SCAN UP when the unit has been identified. This may take up to two minutes. Release the SURF and System (VCR or CBL) buttons as soon as channel numbers start to scan up. The code has been identified and the remote is ready to operate with the VCR or Converter.
STOP

MUTE

STOP s

PAUSE II SURF

VOL

CH

ON/OFF

POS

SWAP

FREEZE SIZE

4

100+ TV/VCR SLEEP SMART POWER
ENTER

1 4 7

2 5 8 0

3 6 9

VCR M

CBL O D

TV E

SMART HELP
Remember, a minute or two can seem very long, but the code should be located within two minutes. Don't let the VCR scan up more than five channels. If you do the remote may pass up the right code and another two minute search cycle will have to be repeated. If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work with the desired unit.
34

2

4