ENGLISH 11
combs should be cleaned in a degreasing liquid (e.g. Norelco Razor Cleaner, Model RC1776, or alcohol) and lubricated with Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head).
4
Remove and clean one set of heads at a time. Separate the cutter from the comb and rinse clean under hot water.
C
5
Every Six Months:Trimmer
1 Turn razor OFF. 2 Push Trimmer Slide Switch up to pop up Trimmer.
� Do not clean more than one cutter and comb at a time, since they are all matching sets. If you accidentally interchange the cutters and combs, it could take several weeks before optimal shaving performance is restored.
C
6 Replace the set back into the Head Assembly in such a way that the sides with the little holes point to the middle of the shaving unit. � Make sure that the two pointy edges of the head fit exactly into the recesses. 7 Repeat the process for the other two sets of cutters and combs. 8 Replace the frame.
C
3 Clean Trimmer with the brush.
C
4 Lubricate the Trimmer teeth with Norelco Razor Lubricant (model AL80) or with one drop of mineral oil. 5 Close Trimmer by sliding Trimmer switch down. This razor has no other user-serviceable parts. Any other service should be performed by an Authorized Norelco Service Location.
C
9 Press down and turn wheel clockwise until it locks into place.
10 Replace the Razor Head Assembly back on
razor. � If the razor heads have been properly inserted, a shiny circle is visible in the middle of the razor head assembly.
Once A Month: Razor Heads
� For optimum performance, razor cutters and
