|
Usuarios conectados
Actualmente hay 5780 visitantes y 9 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Model 596LB User Guide
DYNAMIC HAND-HELD COMMUNICATIONS MICROPHONE
MOUNTING The 596LB is provided with a rear-case hang-up button for use with a mounting bracket on or near associated equipment. The bracket has mounting holes with clearance for No. 6 or No. 8 screws (not supplied). CONNECTIONS The internal switch connections of the 596LB are shown in Figure 1. The 596LB has a four-conductor, coiled-cord cable (two conductors shielded) and a double-pole, double-throw, push-button switch to control the microphone circuit and an external relay or switching circuit. The RED and BLACK unshielded leads control the relay or switching circuit. Refer to the following tables and to the wiring diagram below.
INPUT TYPE WIRE COLOR WHITE UNBALANCED GREEN SHIELD WHITE FUNCTION AUDIO AUDIO GROUND CHASSIS GROUND AUDIO + AUDIO � CHASSIS GROUND XLR CONNECTOR PIN 2 PIN 3 PIN 1 PIN 2 PIN 3 PIN 1 1/4 IN. PHONE PLUG TIP SLEEVE SLEEVE TIP RING SLEEVE
GENERAL The Shure Model 596LB is a compact, hand-held dynamic, low-impedance communications microphone with a 200 to 5,000 Hz frequency response. Designed especially for voice communications use, it is an economical unit for applications in budget-restricted paging and other installations. The microphone is compatible with many popular paging amplifier inputs. Its tailored frequency response provides clear, intelligible operation. The ARMO-DUR® case is small, light and sturdy, and fits comfortably in the palm of the hand. It has a long-life push-to-talk switch, and a durable coiled cable for years of reliable performance. The 596LB has a low-impedance output. The 596LB is furnished with a sturdy mounting bracket for permanent installation. Features
� � � � � � � � � Omnidirectional pickup pattern for optimum off-axis operation Frequency response from 200 to 5,000 Hz, tailored for voice communications Economical-the perfect choice for modest paging installations Rugged and dependable under most operating conditions Silver-plated switch contacts for long-term low contact resistance and reliable performance Long-life vinyl-jacketed coil-cord for years of trouble-free operation Output impedance matches most paging amplifier inputs Virtually indestructible ARMO-DUR case Sturdy, convenient mounting button for attaching to equipment or nearby surface using supplied mounting bracket
BALANCED
GREEN SHIELD
W6 W1 S1 N.C. W2 C4 .001 MK1 W3
BLACK RED
SWITCH CLOSURE SWITCH CLOSURE
WHITE
AUDIO + AUDIO �
GREEN
SHIELD
WIRING DIAGRAM FIGURE 1
The 596LB can be wired for balanced-line operation and is recommended for use where long cable lengths are required, or conditions where severe hum pickup may exist. The 596LB can be fed directly into a standard low-impedance amplifier input, or a Shure A95 Series Line Matching Transformer (at the equipment end of the cable) can be used for coupling the 596LB to the input of a high-impedance amplifier. A two-conductor shielded cable can be used for extending only the microphone circuit. If both the microphone and the remote circuit are to be extended, a four-conductor with two shielded conductors should be used. The microphone circuit of the 596LB is normally open when the microphone switch button is not depressed.
Printed in U.S.A.
©2006, Shure Incorporated 27D2756 (Rev. 5)
|
|
|
> |
|