|
Usuarios conectados
Actualmente hay 5460 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
ADDING CHANNELS TO THE TV'S MEMORY
When you When you press Channel or , your TV will stop only on the channels stored in the TV's channel memory. Follow the steps below and on the next page to program all active channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are stored automatically, you can manually add or erase individual channels. To program channels automatically:
Adding and erasing channels manually
After you have programmed the channels automatically, you can manually add or erase specific channels. To add or erase channels:
1 Select the channel you want to add or erase. If you are
adding a channel, you must select the channel using the Channel Number buttons.
1 2 3
Press MENU, and then press menu appears.
or
until the SET UP
2 Press MENU, and then press
Press or until the TV/CABLE is highlighted, and then press ENTER to display the pull-down menu. Press or to highlight either TV or CABLE, depending on which you use. If you use an antenna, highlight TV; if you use cable, highlight CABLE. Press ENTER. Press to select CH PROGRAM. menu appears.
or
until the SET UP
3 Press 4 Press
or to highlight ADD/ERASE, and then press ENTER to display the pull-down menu. or to select ADD or ERASE, depending on the function you want to perform. erase.
4 5 6
5 Repeat steps 1-4 for other channels you want to add or
Press ENTER to start channel programming. The TV will automatically cycle through all the TV or Cable channels (depending on which you selected), and store all active channels in the channel memory. While the TV is cycling through the channels, the message "Programming Now-Please Wait" appears. When channel programming is complete,the message "Completed" appears. Press Channel or to view the programmed channels.
7 8
Note: To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control.
- 23 -
|
|
|
> |
|