Programming the Remote Control
Now try to use the remote control with the accessory device to see if it is correctly programmed.
DVD619 STANDBY-ON DVD/CD PLAYER OPEN/CLOSE STOP PLAY PAUSE PREV NEXT
4 5
Press the Select button on the remote to select the type of device. When the mode you desire lights up, stop pressing the button. When the light begins blinking the remote is ready for use with the device. Press the Standby�On button. As long as the light keeps blinking, you can use the remote with the selected device. Once the light disappears, the remote is back in TV mode. If the device does not respond to the Standby�On command, repeat steps 16 using a different code. If there are no other for the type and brand of accessory device, the remote likely will not operate your particular model of accessory device.
INFO SELECT DNM
5
TV CC SURR HD SCREEN FORMAT
®
4
SURF
® ®
®
PIP
P
NOTE: Your TV remote is not necessarily capable of operating all models of the brands of accessory devices listed on pages 24�25. You may want to try the programming process again. Try using the number(s) that are listed for your type and brand of device to be sure you did not make a mistake in inputting the digits during your first attempt at programming.
AV+
SAP
AUTO
CONTROL
ACTIVE
TIMER
SLEEP
CLOCK
AUTO
c CHECK IT OUT
You can change the duration of the time-out mode by simultaneously pressing the Select button and a digit button, 1�4. Using digit 1 will set the time-out to 15 seconds; digit 2, 30 seconds; digit 3, 60 seconds; and digit 4, 120 seconds. The default time-out setting after you replace the batteries in the remote is 60 seconds. All modes will have the same timeout setting.
HELPFUL HINT
If the remote control is in one of the accessory modes (a mode light is flashing)� CBL, VCR, DVD, SAT, AMP�and you don�t press any of the remote buttons for sixty seconds, a �time-out� occurs, returning the remote to TV mode.
23
