Operating sequence
Before the first wash we recommend that you pour 2 litres of water into the main wash compartment of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.
4. Select the desired programme
Turn the programme selector dial to the desired position.
1. Place the laundry in the drum
Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. The light corresponding to the max spin speed for the selected programme illuminates and the light of the Start/Pause button starts to flash.
5. Select the required option(s)
The light corresponding to the depressed button illuminates. When selecting the Rinse Hold option the water of the last rinse is not emptied out, to prevent the fabrics from creasing.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out a programme with prewash or a stain phase, pour detergent into the appropriate compartment marked . Please do not use liquid detergent with this appliance except if placed in the dosage ball/device & at the back of the machine drum.
6.Select Spin Speed
Press the Spin Reduction button repeatedly to reduce the spin speed. The relevant light illuminates.
3. Measure out the additive
If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark.