se the START TIME control to set the TV to turn itself on at a specific time (see the previous page). The following steps will guide you in setting the TV to turn itself off.
BEGIN
Press the MENU/SELECT button on the remote control to show the on-screen menu. Press the CURSOR RING DOWN twice to highlight FEATURES. Press the CURSOR RING RIGHT to enter the FEATURES menu.
PICTURE SOUND FEATURES INSTALL
TIMER AUTOLOCK PIP CLOSED CAP FEATURES TIMER AUTOLOCK PIP CLOSED CAP TIME START TIME STOP TIME CHANNEL TUNER MODE
POWER
FEATURES TIMER TIME START TIME STOP TIME CHANNEL TUNER MODE 8:02 PM
Press the CURSOR RING RIGHT again. Then press the CURSOR RING DOWN twice to highlight the STOP TIME control. Press the CURSOR RING RIGHT to highlight the time indicator area. Press the NUMBER buttons to enter the correct time. If you make a mistake entering the time, use the CURSOR RING LEFT or RIGHT to move among the input slots to make corrections. NOTE: You can also use the CURSOR RING UP or DOWN to cycle through digits to input the time. Press the CURSOR RING UP or DOWN to select AM or PM. Press the STATUS/EXIT button to remove the menu from the screen.
TV SWAP DN SOUND VCR PIP CH UP PICTURE SOURCE ACC FREEZE
5 3 4
FEATURES TIMER TIME START TIME STOP TIME CHANNEL TUNER MODE
7
8
STATUS/ EXIT
MENU/ SELECT
_ _:_ _
VOL
MUTE
CH
1
2
1 4 7
TV/VCR A/CH
FEATURES TIMER TIME START TIME STOP TIME CHANNEL TUNER MODE 9:30 AM
