Possible cause/Remedy < Verify if the supplied cables are connected properly. (The aerial cable to the TV, the other aerial to your recorder, the power cables, ..) < Verify if you selected the correct source. < Verify if the child lock has been switched off. < Verify in the Manual installation menu if you have selected the correct TV system. < Verify if your TV or house aerial isn't located too close to loudspeakers, non-earthed audio equipment or neon lights, etc. < Mountains or high buildings can cause double pictures or ghost images. Sometimes you can improve the picture quality by changing the direction of the aerial. < Is the picture or teletext unrecognisable.Verify if you have entered the correct frequency. See Installation, Manual installation, p. 26. < Select Factory settings in the Installation menu. < Verify the connections between the optional equipment and the TV. < Verify if the volume isn't at minimum. < Verify if the sound hasn't been muted with the ¬ key. < Verify the connections between the optional equipment and the TV. < Verify if the remote is set correctly for the equipment your are using. < Verify if the batteries are not dead. Replace the batteries. You can still use the keys at the right side of the TV. < Select TV mode on your remote control. < The infrared signals of the screen may influence the reception sensibility of other peripherals. Solution: replace the batteries of the remote of other peripheral equipment.
Poor picture
Poor colour
No sound
The remote does not function
The remote of connected equipment does not function well
No photo or music < Verify if the source complies with a supported code. play or in poor quality No stable or not synchronised VGA picture < Verify if you have selected the correct VGA mode in your PC. See Connect a PC, p. 45. < Verify the connections between the PC and the TV.
No solution found < Switch off your TV off and then on again once. for your picture or Never attempt to repair a defective TV yourself. sound problem Verify with your dealer or call a TV technician. Red blinking led < Unplug the mains cord for 10 seconds and insert it in again.
