Su carrito de compras está vacío
 
English Polski Spanish 
Buscar un manual
 

(p.Ej. AA-V20EG JVC, ZX-7 Sony)
PayPal 1000+ rating Secure, Encrypted Checkout.
 
Usuarios conectados
Actualmente hay 6026 visitantes y 
17 usuarios online.
Productos
Información
Destacado
Inicio >> TOSHIBA >> 40PW03G Diagrama del circuito
 
 0 artículo(s) en Su carrito 

TOSHIBA 40PW03G
Diagrama del circuito


¡Twitee acerca de este producto y obtenga $1.00 de crédito en la tienda para uso!
  • Contiene diagramas del circuito
  • Descargable
  • Formato PDF
  • Idiomas: English
Precio: $4.99

Descripción del TOSHIBA 40PW03G Diagrama del circuito

Conjunto de diagramas del circuito. Los diagramas serán proporcionados en un archivo PDF. El archivo será enviado después de que realice la compra.

The manual is available in languages: English

Not yet ready
You must purchase it first

Opiniones de los clientes
No hay comentarios de productos.

TEXT_PDF_SNIPPET
SCHEMATIC DIAGRAM 40PW03B

MODEL :

40PW03G /

CAUTION: The international hazard symbols "*" in the schematic diagram and the parts list designate components which have special characteristics important for safety and should be replaced only with types identical to those in the original circuit or specified in the parts list. The mounting position of replacements is to be identical with originals. Before replacing any of these components, read carefully the PRODUCT SAFETY NOTICE on page 3. Do not degrade the safety of the receiver through improper servicing.

CBSERVATION OF VOLTAGES AND WAVEFORMS 1. Voltages read with VTVM from point shown to chassis ground, line voltages 220 volts, colour bar signal. Voltage reading may vary ±20%. 2. All waveforms are taken using a wide band oscilloscope and a low capacity probe. 3. Waveforms are taken using a standard colour bar signal. 4. Make sure that CONTRAST and COLOUR controls are in mid position and BRIGHTNESS control is almost in maximum position. Set other controls for best picture.

NOTES: 1. D.C. resistance value of a principal transformer is shown in this schematic diagram. These are measured for separated from the circuit. 2. The circuits are subject to change without notice. 3. : Solder links.

EXPRESSION VALUE OF RESISTOR, CAPACITOR and INDUCTOR 1. Resistance is shown in ohm, K=1,000, M=1,000,000 2. Unless other wise noted in schematic, all capacitor values less than 1 are expressed in ?F and the values more than 1 in pF. 3. Unless other wise noted in schematic, all inductor values more than 1 are expressed in ?H, and the values less than 1 in H.

Quizás también quiera comprar

$4.99

40PW03G TOSHIBA
Manual de Servicio

Manual de servicio completo en formato digital (archivo PDF). Los manuales de servicio por lo genera…
>
Parse Time: 0.163 - Number of Queries: 102 - Query Time: 0.039