PHILIPS 36PW9525/79R
Manual de Usuario

Connect Extra loudspeakers / Amplifier
REAR multimedia loudspeakers You can enjoy Dolby Pro Logic Surround sound by connecting two rear loudspeakers to be connected or to the connector clips (if provided) or to the Dolby Surround output S at the back of your TV. To the connector clips (if provided)

or

To the output S

AUDIO S

R

L

REAR

&

Connect two Surround Sound rear loudspeakers (min. 16 �) to the connector clips at the back of the TV. Always connect both Surround Sound loudspeakers: the left rear loudspeaker at REAR L; the right rear loudspeaker at REAR R. Push the connector clip down and insert the end of the wire into the opening: the positive wire (the one with the black line) to the red loudspeaker connection; the negative wire to the black loudspeaker connection. Do not insert the wires too far. The Surround Sound loudspeakers should always be located behind or to either side of the listener. If preferred you can also hang the loudspeakers on the wall.

&

Connect two rear loudspeakers with built in amplifiers (or an audio amplifier with rear loudspeakers). Connect the audio cables to the rear loudspeakers and to the Dolby surround output S at the back of your TV as shown above. There is only one cinch output for both speakers. Use a mono to stereo adaptor. Note: Switch off the TV and the rear loudspeakers before connecting them. Select Rear speakers Yes in the Setup menu. See p. 7. See Surround settings, p. 14 for the available Surround modes. Rear Surround Sound loudspeakers should always be located behind or to either side of the listener at about 1 m above the seated listener�s head. Adjust the volume of the rear loudspeakers. You may make use of the Test tone function in the Surround settings menu, see p. 13, to have a reference of the loudness of the separate loudspeakers. Note: Once you have adjusted the volume of the rear loudspeakers, do not change it while watching TV as the whole configuration operates with the volume adjustment of your TV.

é

é

Select Rear speakers Yes in the Setup menu. See p. 7. See Surround settings, p. 14 for the available Surround modes. Rear Surround Sound loudspeakers should always be located behind or to either side of the listener at about 1 m above the seated listener�s head. Adjust the volume of the rear loudspeakers. You may make use of the Test tone function in the Surround settings menu, see p. 13, to have a reference of the loudness of the separate loudspeakers. Note: Once you have adjusted the volume of the rear loudspeakers, do not change it while watching TV as the whole configuration operates with the volume adjustment of your TV.

�

�

Connect Peripheral Equipment

27