|
|
|
Usuarios conectados
Actualmente hay 6043 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Installing your television set
& Positioning the television set
5 cm
� Remote control
5 cm
5 cm
Place your TV on a solid, stable surface, leaving a space of at least 5 cm around the appliance. To avoid accidents, do not put anything on the set such as a cloth or cover, a container full of liquid (vase) or a heat source (lamp).The set must not be exposed to water.
é Connections
Insert the two R6-type batteries (supplied) making sure that they are the right way round. Check that the mode selector is set to TV. The batteries supplied with this appliance do not contain mercury or nickel cadmium. If you have access to a recycling facility, please do not discard your used batteries (if in doubt, consult your dealer).When the batteries are replaced, use the same type.
� Switching on
FM. ANT.
� Insert the aerial plug into the : socket at the rear of the set. � For the versions equipped with a radio: insert the radio aerial socket into the FM ANT socket. If you are using an indoor aerial, reception may be difficult in certain conditions.You can improve reception by rotating the aerial. If the reception remains poor, you will need to use an external aerial. � Insert the mains plug into a wall socket (220240 V / 50 Hz).
To switch on the set, press the on/off key. A red indicator comes on and the screen lights up. Go straight to the chapter Quick installation on page 4. If the television remains in standby mode, press P # on the remote control. The indicator will flash when you use the remote control.
The keys on the TV set
The television set has 4 keys which are located on the front or the top of the set depending on the model. The VOLUME - + (- � +) keys are used to adjust sound levels.The PROGRAM - + (- P + or - +) keys are used to select the required programmes.To access the menus, simultaneously hold down the � - and � + keys.The PROGRAM - + keys may then be used to select an adjustment and the - � + keys to make that adjustment. To exit from the menus, hold down the 2 � and � + keys. Note: when the Child Lock function is activated, these keys are unavailable (refer to Features menu on page 7). 2
|
|
|
> |
|
