PHILIPS 286NS/05
Manual de Usuario

Tips for tuning
Changing the pr ogramme number of a television channel
2 3 4 5 switch the equipment on one piece at a time and check the picture on all your programmes. The pieces of equipment that are not switched on must be on stand-by. If any of your programmes have wavy lines on the picture when the equipment is switched on, you will have to change the output frequency of the equipment. Please read the instruction book for the equipment to find out how to do this. Change the output frequency a little at a time (or in 8MHz steps) and keep checking all your programmes. When there are no wavy lines (or other interference) on any of the pictures, re-tune the programme number that you have chosen for your equipment (see �Tuning in the programmes� on pages 2 to 3). Do the same for each piece of equipment, but after you�ve finished with each one, leave it switched on while you check the next piece of equipment. Continue until you have all the pieces of equipment working together without interfering with each other. If you cannot get rid of the interference, you may have to connect the equipment with a scart cable, (see �How to connect scart cables� on page 9).

1

Press the N and Q buttons together to get the installation menu on the screen. Press the menu + button to get the manual store menu on the screen. Select the channel you want to change by pressing the P+, P- or the 0 to 9 buttons. Press the N and Q buttons together again to make the programme number flash. Press P+, P- or the 0 to 9 buttons to enter the programme number you want to give to that channel. You can�t use 0 because it is reserved for the scart (AV) channel. Press the N and Qbuttons together once more to make �stored� appear. The television has now stored the television channel on the programme number you have chosen.

6

7 8

Repeat steps 3 to 6 if you want to change the programme numbers of other channels. Press the menu button twice to get back to normal viewing. (You can turn off any of the on-screen displays by pressing the menu button several times.)

Changing channels without leaving the installation mode
As long as the programme number is not flashing, you can change channels while the installation menu is still on the screen.

Picture interference from other equipment
If you have used the aerial lead to connect a video recorder, satellite receiver or other piece of equipment,

Features on the television
Main po wer switch

A
Push to open the control fla p

Please read �Switching the television on and off� on page 2.

To open the control cover flap near the front right-hand corner of your television, push on the raised pips near its upper edge and release it. The flap opens to reveal the menu buttons and headphone socket. Push the flap to close it. Keep pressing the menu button to display the symbols for the items you can adjust: a (volume), b (balance), tone l (treble) or m (bass), A (brightness), B(contrast), R (sharpness), C (colour) and C (the timer). If you don�t make any adjustments, the menu display will automatically disappear after 10 seconds. When there is no symbol shown on the screen, the - button selects the previous programme number and the + button selects the next programme number. Brightness, contrast, colour and sharpness are picture adjustments. Your television displays a bar to show the adjustment. Press + to increase the item you are adjusting, and the bar will get longer. Press � to reduce the item you are adjusting, and the bar will get shorter. Volume is for making the sound louder or quieter. Balance changes the balance of sound between the left and right loudspeakers. Tone emphasises the bass in the sound if the on-screen bar is short, or the treble in the sound if the on-screen bar is long. 4

n

Menu adjustments