|
|
|
Usuarios conectados
Actualmente hay 5828 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
TE430VX SPECIFICATION UPDATE
DOCUMENTATION CHANGES
The Documentation Changes listed in this section apply to the TE430VX Motherboard Technical Product Specification (Order Number 281817). All Documentation Changes will be incorporated into a future version of the appropriate TE430VX motherboard documentation.
1.
Revision of Section 1.11.3, Wavetable Connector
This second paragraph in this section will be replaced in its entirety as follows: Compatible wavetable cards are available from several vendors.
2.
Revision of Section 5.2, Specifications
The following note will be added to the table entry for PCI compliance:
NOTE: Certain optional PCI features have not been implemented on this motherboard, see section 1.14 for more information.
3.
�
Revision of Section 1.7.1, 82437VX Xcelerated Controller (VXC)
Fully synchronous PCI bus interface    25/30/33 MHz PCI to DRAM data transfers up to or greater than 100 MB/sec Up to 4 PCI masters in addition to the PIIX3
The fourth bullet in this section will be replaced in its entirety as follows:
4.
Revision of Section 1.12.4, Add-In Board Expansion Connectors
The text in the first paragraph of this section will be replaced in its entirety as follows: The motherboard Expansion Slots support up to four bus mastering PCI and up to three ISA add-in boards. One of the PCI slots may be shared with an ISA slot.
5.
Revision of Section 1.13.3, Clear CMOS (J9C1-A)
This section will be replaced in its entirety as follows: Allows CMOS settings to be reset to default values by moving the jumper from pins 4-5 to pins 5-6 and turning the system on. When the system reports that �NVRAM cleared by jumper�, the system can be turned off, and the jumper should be returned to the 4-5 position to restore normal operation. Default is for this jumper to be on pins 4-5. Caution: This procedure should only be done if, after a BIOS update, the system does not boot to a point where BIOS Setup can be entered or if, after CMOS default settings have been restored from within the Setup program, the system does not boot to the operating system.
14
|
|
|
> |
|
