BANG&OLUFSEN 2612
Manual de Servicio

9

Storing stations on program numbers
Once you have found the station you want and are hearing it clearly in the loudspeakers, you can store it on a program number of your own choice. This enables you to access the station directly by keying in the appropriate number. You can store 15 different radio stations in each of the two tuner blocks A and B.
Note: You may store an extra 5 stations in each block (on the program numbers from 16 - 20), but the stations on these numbers cannot be named (see below). You can use the CLEAR button to clear a program number entirely, that is, to remove all the data you have previously stored on it. To do so, press CLEAR twice while you are on the program number you want to clear. To store the station you are listening to, press Key in the number on which you want to store the station, for example 1 Press again to store the station ACCEPTED appears in the display, indicating that the station has been stored on the chosen number Proceed to tune in to the next station you want, then store it on one of the other program numbers from 1-15.
STORE STORE

1

Naming stations
You can give a short name of your own choice to all the stations you have stored.
The name may contain up to 8 characters,

RADIO B

CLASSIC

STEREO

Select the program number on which you have stored the station To access the naming function 2x
GO TO

This enables you to remember a station not only by its program number, which you need for access, but also by a particular name. The name of the station you are listening to appears in the lower display.

including numbers. If you haven�t given a name to a station, the station�s own name appears instead, providing such a name is transmitted by the station.

The cue NAMING: appears briefly, then the display blanks. If you have already entered a name, that name will appear The first of the eight character positions blinks, indicating that you can start �writing� a name Reveals the characters one by one
STEP

>
or

< STEP
Moves to the next character position or

Stores the name Note: The naming function requires that your BeoCenter is equipped with the RDS facility. If you want to clear the name press CLEAR instead of STORE

STORE