|
Usuarios conectados
Actualmente hay 6043 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
Installing your television set
æ Positioning the television set
Place your TV on a solid, stable surface, leaving a space of at least 5 cm around the appliance. To avoid accidents, do not put anything on the set such as a cloth or cover, a container full of liquid (vase) or a heat source (lamp).The set must not be exposed to water.
� Connections
� Insert the aerial plug into the M socket at the rear of the set. Smaller sets are equipped with an internal aerial. Under certain conditions, reception can be poor.You can improve it by repositioning the aerial. If the reception remains unsatisfactory, an external aerial should be used. � Insert the mains plug into a wall socket (220-240 V / 50 Hz).
ê Remote control
Insert the two R6-type batteries (supplied) making sure that they are the right way round. The batteries supplied with this appliance do not contain mercury or nickel cadmium. Please do not discard your used batteries if you have access to a recycling facility (if in doubt, consult your dealer).When the batteries are replaced, use the same type.
® Switching on
To switch on the set, press the on/off key. A red indicator comes on and the screen lights up. Go straight to the chapter Quick installation on the following page. If the television remains in standby mode, press P on the remote control. The indicator flashes when you use the remote control.
The keys on the TV set
The television set has 4 keys which are located on the front or the top of the set depending on the model. The VOLUME - + (-a+) keys are used to adjust the sound level. The PROGRAM - + (- P +) keys are used to select the required programmes. To access the menus, hold down the VOLUME - and VOLUME + keys simultaneously.Then use the PROGRAM - + keys to select an adjustment and the VOLUME - + keys to make the adjustment. To exit from the menu, hold down the VOLUME - and VOLUME + keys for a few seconds. Note: when the LOCK function is activated, these keys are unavailable (see page 6).
2
|
|
|
> |
|