AEG 2060D-M/GB
Manual de Usuario

Wall unit mounting - Fig. 6
� Position the template (1) on the wall and mark the position, and drill (2) the holes (2 x � 8 mm). � Mount the two rawl plugs with the hooks (3). � Hang the hood on the hooks and level it with the adjustment screws (4). � Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x � 8 mm). � Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it horizontally with the screws (8) and secure it with the screws (9). � Mount the chimney holder (10) with the rawl plugs (9) and the screws (11). Be careful that it is centered over the hood and horizontally aligned. � Fitting for extractor version (S): Connect a tube between the hood air outlet and the wall or roof exhaust channel. Note that the top part of the chimney can be mounted with the side grids up or down. For use as an extractor version hood it must be mounted with the grids downwards. Fitting for filter version (K): Mount the deflector (12) with the two screws (13) supplied. � Make electrical connection (14) (see paragraph �Electrical connection�) � Place the chimney (15) and fix it to the top chimney holder with the two screws (16) supplied. Lower the bottom part of the chimney and fasten it to the top of the hood with two screws (17), supplied. Note that the top part of the chimney can be mounted with the side grids up or down. For use as a recirculation hood it must be mounted with the grids upwards.

17