General Troubleshooting Guide (Continued)
Resolution can not be changed and LightFrame not work on Mac PC
Resolution can not be changed and LightFrame not work on Power Mac
YES 1. Test monitor with different IBM pc NO 1.1. Consulted by system/video chipmakers for the right version of video chip drive
YES 2. Right video card/ driver,but resolution still not changeable NO 2.1 Consulted by system/video chip makers for the right version of video chip driver
YES 3. Right monitor type for your Mac system NO 3.1 Consulted by system makers for the desired resolution
YES 4. Proper VGA Adaptor for your Mac NO 4.1 Consulted by system makers for the proper VGA Adaptor and where to buy
4.1. VGA Adaptor is the interface between
Mac and normal IBM VGA monitor, see the figure.(It's one kind of sample only) 4.2. Resolution changed on Mac is done by setting of DIP switch of the adaptor (change ID configuration) 4.3. Power Mac G4 has been implemented the VGA feature on Mac system(3 rows,15 pins D-shell connector) 5.1. Only power Mac G4 can run LightFrame or other Mac which system output with VGA 15 pins(3 rows) D-shell connector 5.2. The LightFrame not work on Mac due to Mac dis-connect DDC output for IBM VGA Monitor(pin 12 for SDA and pin 15 for SCL) 5.3. Sub-content:pcstuff.
6.1. Please be noticed that LCD monitor can not run the LightFrame
YES 5. LightFrame still not possible to install for Mac NO 5.1 LightFrame can not run on mac except Power Mac G4
