WHIRLPOOL 1DNET3205TQ0
Manual de Usuario

NOTE: If your model has a liquid fabric softener dispenser, do not wash clothes with this dispenser removed. Do not add detergent or bleach to this dispenser; it is for liquid fabric softener only.

Cleaning the Dryer Interior
To clean dryer drum
1. Apply a nonflammable household cleaner to the stained area of the drum and rub with a soft cloth until stain is removed. 2. Wipe drum thoroughly with a damp cloth. 3. Tumble a load of clean cloths or towels to dry the drum. NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

Water Inlet Hoses
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear or leaks are found. When replacing your inlet hoses, mark the date of replacement on the label with a permanent marker.

Cleaning the Lint Screen
Clean the lint screen before each load. A screen blocked by lint can increase drying time. IMPORTANT:
�

Removing Accumulated Lint
From Inside the Dryer Cabinet Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person. From Inside the Exhaust Vent

Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics. If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. Every Load Cleaning

�

Style 1: 1. The lint screen is located inside the dryer on the back wall. Pull out the lint screen and its cover. 2. Separate the cover and the screen by squeezing the screen and pulling on the cover at the same time. 3. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 4. Put the lint screen and cover back together and push firmly back into place. Style 2: 1. The lint screen is located inside the dryer in the front door well. Pull the lint screen straight up. 2. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 3. Push the lint screen firmly back into place. As Needed Cleaning Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off the screen. Clean the lint screen (as outlined following) every 6 months, or more frequently if it becomes clogged due to a residue buildup. 1. Roll lint off the screen with your fingers. 2. Wet both sides of lint screen with hot water. 3. Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup. 4. Rinse screen with hot water. 5. Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

Lint should be removed every 2 years, or more often, depending on dryer usage.

Vacation, Storage and Moving Care
Non-use or vacation care
Operate your washer/dryer only when you are at home. If you will be on vacation or not using your washer/dryer for an extended period of time, you should:
� �

Unplug washer/dryer or disconnect power. Turn off the water supply to the washer. This helps avoid flooding (due to a water pressure surge) while you are away.

To transport the washer/dryer
1. Shut off both water faucets. 2. Disconnect and drain water inlet hoses. 3. Disconnect the drain from the drain system. 4. Unplug washer/dryer or disconnect power. Disconnect wiring if washer/dryer is direct wired. 5. Disconnect the exhaust vent. 6. Wash lint screen. 7. Make sure leveling legs are secure. 8. Place the inlet hoses into the basket. 9. Drape the power cord and drain hose over edge and into the basket. 10. Use masking tape to secure the washer lid and dryer door.

Reinstalling your washer/dryer

1. Follow the �Installation Instructions� to locate, level and connect the washer/dryer. 2. Run the washer through a complete cycle with 1 scoop or capful of detergent to clean the washer.

6