VENTILATION REQUIREMENTS
The appliance must have adequate ventilation to ensure correct operation. The diagram shows the ventilation requirements when installed: A* Under a worktop or cupboard B freestanding * The clearance space of 10cm above the appliance may be reduced to 5cm providing a clearance space of 2.5cm is left either side of the appliance.
LEVELLING
The appliance MUST be level. Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance.
DOOR REVERSAL
Should you wish to reverse the direction that the door opens, follow the instructions and diagrams below. Ensure that the appliance is disconnected from the electricity supply before reversing the door. To reverse the bottom hinge assembly proceed as follows: Tilt the appliance backwards, resting the top edge of the appliance on a stool or something similar. Unscrew the adjustable feet situated on both sides at the front (2 pieces). Remove the lower door hinge plate by unscrewing the 3 retaining screws. Remove the hinge pin from the bottom of the door. Slot the hinge pin into the hole in the hinge pin plate and relocate the hinge pin assembly to the opposite location and refit using the retaining screws. Return the cabinet to an upright position.
