2-4. Sensor PC Board
1. Remove one screw (1) and remove the connector (2) from the one location, then remove the sensor PC board (3).
Screw (1)
2-5. LCD Rear Cover
1. Remove the front panel, the LCD panel and the inverter PC board. (Refer to item 1-1, 1-2 and 1-3.) 2. Remove two screws (1), then remove the support (2). 3. Remove two screws (3) and remove the LCD rear cover (4) in a vertical position. Note:
Connector (2)
� If not removed when in a vertical position, the hinges may become deformed.
Sensor PC board (3)
LCD rear cover (4)
Screws (3)
Fig. 1-2-9
Note: � When attaching the sensor PC board (3), bundle the wires with the band (4) and insert into groove then attach the sensor PC board (3) from the top.
Sensor PC board (3) Band (4) Wires
Support (2) Screws (1)
Guide
Fig. 1-2-11
Place the bundled wires (4) into this groove and attach the sensor PC board (3) on the top.
