ZANUSSI ZU7115
Manual de Usuario

Hook the decorative panel onto the top part of the door, inserting the pins (B) (on the door) into the elongated holes (1) (in the top bracket fitted to the panel). Insert the securing screws (C) through elongated holes (2) and fix the panel without tightening the screws.

1 B

C

D533

2

Once the top of the panel has been correctly positioned, fix it through the holes in the bottom bracket, without tightening the screws.

D471

Check the position again by slackening the screws and pins then, once the best position has been obtained, fully tighten all the fixings. Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket.

D

D472

Once the door has ben correctly aligned, tighten the holding nuts on the fixing brackets and attach the appliance to the adjacent units and the bottom of the work surface.

D517

For a correct installation operation if the base plate is more than 100 mm (for cavity height 820 mm) or more than 150 mm (for cavity height 870 mm) you must cut out the plate as shown in the diagram.

450

D593

16