ZANUSSI ZI609
Manual de Usuario

Fixing to the adjacent units
Insert the two fixing brackets into the slots provided in the top front part of the dishwasher, as shown in the figure. Secure the brackets to adjacent units using two 3,5 x 16 screws for each bracket.

Levelling
Make sure that the dishwasher door closes properly, without rubbing on sides. Otherwise level the machine by slightly screwing or unscrewing the two front feet until perfect closure of the door is reached. Kitchen plinth adjustment To allow correct opening of the door it is sometimes necessary to cut the kitchen plinth. Refer to the cutting table below.

II29

Important! The dishwasher must be secured against tilting. Therefore, make sure that the counter it is fitted under, is suitably secured to a fixed structure (adjacent kitchen cabinets, wall).
II13

Attention! When the dishwasher is secured to the kitchen cabinets, do not drill any holes into the sides of the machine. Adjusting the door balance The door of the dishwasher is balanced when it is open in any position. Fitting the decor panel may sometimes affect this balance. In this case it will be necessary to adjust the balance as follows: Half-open the door and regulate the screws located on the kick plate.
II08

According to dimensions of (a) and (b) as shown on the figure, you will find on the following table the depth (x) of the cut to be made on the plinth.
a
II15

The dimensions (a) and (b) of the table are those more frequently used in the kitchen furnitures.

Depth (b)*

b

Height (a)*
1 7 0 1 6 0 1 5 0 1 4 0 1 3 0 1 2 0 11 0 1 0 0 40 136 131 125 118 110 100 93 85 50 135 131 125 118 110 102 92 85 60 137 132 125 118 110 102 94 85 70 138 134 128 120 110 104 95 85 80 90 100 / / /

By screwing or unscrewing these screws, the tension of the door balancing springs is increased or decreased respectively. Attention! The weight of the panel should be within the limits given in the "dimensions of the panel", otherwise balancing the door will not be possible.

X

139 130 124 115 105 98 88
/ /

138 129 120 110 100 90
/

135 125 115 105 95

*dimensions in mm

600 mm (minimum)

X
Dimensions of the cut on the plinth

PII04GB

37