ZANUSSI ZFC240CL
Manual de Usuario

Door reversal directions
Before starting work, unplug the appliance. To reverse the opening direction of the door proceed as follows: Remove the lower hinge (3), the pin (1), the washer (4) and the screw (2); slide the door out from the pin (5), remove the pin and place it on the opposite side; unscrew the foot front left and place it on the opposite side; unscrew the two screws which mask the holes for �xing the hinge on the front left side; reassemble the door; re�t the lower hinge (turning it 180°), the washer, the pin and the screw on the opposite side, as shown in the �gure. remove the handle, after having removed the screw cover and re�t it on the opposite side. The holes that are not used must be masked with the plastic plugs removed. Attention After completion of the door reversibility operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not �t perfectly to the cabinet. In that case, wait for the natural �tting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier.
D162 D547 D548

Fig. 3

5

Fig. 3a
4 3
0¡

1 2

18

Fig. 3b

Fitting the door panel
(for models equipped with door frame) To �t the door panel, proceed as follows: � remove the �xing screws and remove the frame side opposite the handle; � loosen, without removing them, all remaining screws �xing the door frame; � insert the panel from the side on which the frame has been removed and push it fully in; � re�t the frame side and tighten all the screws. Note The panel size should be 1-2 mm smaller than the door; the maximum permissible panel thickness is 4 mm.

12