AEG ZERT 2170 X
Manual de Usuario

Installation
Positioning
For this appliance to work efficiently, it must not be located where the temperatures will fall below 10°C (50°F) or rise above 38°C (100°F), e.g. conservatories. For correct operation this appliance must be located in a dry atmosphere, away from heat sources, e.g. cookers, radiators, boilers and direct sunlight. You should also ensure that air can circulate freely around the back and the top of the cabinet. There should be 100mm (4�) between the top of the cabinet and any overhanging kitchen furniture. Alternatively allow 50mm (2�) between the top of the cabinet and any overhanging kitchen furniture and a gap of
10 mm 10 50-100 mm

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers.

D200

25mm (1�) on either side of the appliance.

Aligning the appliance top with the other kitchen units
A B The appliance comes with the top aligned with the door. To change the alignment, follow the instructions below: Remove the screws (A-Fig.) fixing the rear brackets to the top; move the top and, having selected the new position, refit the screws.

NP006

Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation. It is important that the bottom grill is not obstructed as the air must circulate freely through this grill.

D086_a

14