ZANUSSI ZENB2925
Manual de Usuario

OPERATION
Before using
Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.

Door reversal directions
1. Disconnect from the electricity supply. 2. Remove all loose items, including food, store food in a cool place. 3. Gently lay the fridge/freezer on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing. 4. Remove the feet (B). 5. Remove bottom hinge (A). 6. Remove the freezer door by releasing it from the middle hinge (H).
ON
min

B

A B
D715 PIED/M

Control panel

7. Unscrew the middle hinge. 8. Slide out the fridge door from pin (G), unscrew pin (G) and then screw it down into the hinge hole provided on the opposite side, after having removed the small plugs which should then be fitted on the opposite side. 9. Remove the plastic blanking screws from the left hand hinge position, refit to the right hand hinge position. 10.Refit the fridge door and replace the middle hinge to the left hand side. 11.Replace the door and bottom hinge (A) on the opposite side. 12.Refit the feet (B).

H

MAX

AB
A - Pilot light B - Thermostat control knob

To Start the Appliance
Allow the appliance to stand for 2 hours after installation. Plug in the appliance and switch on at the mains supply. Turn the thermostat control (B) to a midway setting and adjust the slider control, situated on the back wall of the fridge section, to a midway position between �MIN� and �MAX�. The pilot light (A) will illuminate. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside. To switch off the appliance turn the thermostat control to position �I�

Setting the temperature
The temperature within the appliance is controlled by the thermostat situated at the top of the appliance. To operate the appliance proceed as follows: Turn the thermostat control beyond the «I» position. Position MIN = minimum coldness Position MAX = maximum coldness Turn the thermostat control knob to the required position. The intermediate position is usually the most suitable. The thermostat control regulates the temperature both within the fridge and the freezer compartment. The thermostat setting can vary as the temperature inside the appliance depends on the following factors: � room temperature � how often the door is opened � how much food is stored � position of the appliance

G

Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.

D419

4

17