ZANUSSI ZDI6053QA
Manual de Usuario

Maintenance and cleaning
Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). Ensure that the seals around the door, the detergent and rinse aid dispensers are cleaned regularly with a damp cloth. We recommend every 3 months to run a 65°C wash programme without dishes using detergent. The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. To ensure a correct working of the dishwasher, NEVER try to remove the upper spray arm. If residues of soil have clogged the holes in the upper spray arm, remove them with a toothpick.

Cleaning the central filter
(After each wash) Scraps of food may accumulate in the drain filter (A) and should be removed by rinsing the filter under running water. To remove the drain filter - simply pull it out by the handle Once cleaned, refit the filter by pushing it back to its original position until it engages.

MA33

Prolonged periods of non-operation
If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. 2. Fill the rinse aid dispenser. 3. Leave the door ajar to prevent the formation of any unpleasant smells. 4. Leave the inside of the machine clean.

Frost precautions
A
MA04
MA19

Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it.

Cleaning the large filter
(Every week) If necessary clean the large filter (B) on both sides under running water, using a brush. To remove the large filter 1. Remove the spray arm by pulling it upwards. 2. Turn the column (C) anticlockwise by 90° and then slide out the filter. 3. Once cleaned refit it following the above instructions in reverse order. 4. Ensure that the filter is in its original position, the handle of the drain filter should be pointing towards the front of the appliance.

Moving the machine
If you have to move the machine (moving house etc....): 1. Unplug it. 2. Turn the water tap off. 3. Remove the water inlet and discharge hoses. 4. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation.

90° B C
MA05
MA20

MA21

MA18

12