SONY XR-CA624X
Manual de Servicio

XR-CA624X

4A

B
c

51
182 m m

2

3
4 5 4

4

Dashboard �表� #####

Fire wall

1

��� #####

6 2 3

53 mm

Bend these claws outward for a tight fit, if necessary.

1

�������������� #####

5 5 4

Precautions
�Choose the installation location carefully so that the unit will not interfere with normal driving operations. �Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. �Use only the supplied mounting hardware for a safe and secure installation. �There must be a distance of at least 15 cm between
the cassette slot of the unit and shift lever in order to insert a cassette easily. Choose the installation location carefully so the unit does not interfere with gear shifting and other driving operations.

Mounting example (5)
Installation in the dashboard

使��注���
� �細�����置�使��妨�正常������ � ��������溫������������ 氣�����塵極�����以�極����� ��� � �使���以��������使������ �件� ������帶槽����桿�������� 15 cm ��以便����帶��������� 置以便使�����妨���������� ��

��示��5�
������裡

Mounting the unit in a Japanese car (6)
You may not be able to install this unit in some makes of Japanese cars. In such a case, consult your Sony dealer.
Note To prevent malfunction, install only with the supplied screws 4.

���������汽��� 6 ��
�����汽����������種�形��� ����� Sony ���諮詢�
註 ��止����������使�����絲 4�

15 cm 15 cm

Warning when installing in a car without ACC (accessory) position on the ignition key switch
Be sure to press (OFF) on the unit for two seconds to turn off the clock display after turning off the engine. ���度�調�
�� 20 °以�調����度�

������������ ACC �����置�汽����警�
���汽��������������� (OFF) ��以����顯示�
��������� (OFF)��������顯 示�浪費�池�

Mounting angle adjustment
Adjust the mounting angle to less than 20°.

When you press (OFF) only momentarily, the clock display does not turn off and this causes battery wear.

RESET �� 4 ����������� �
������������������� RESET ���

How to detach and attach the front panel (4)
Before installing the unit, detach the front panel.

���������������

RESET button
When the installation and connections are completed, be sure to press the RESET button with a ballpoint pen, etc.

4-A ��
������������ (OFF) ������ (OPEN) � �以便�����������微� ������������左����

4-A To detach
Before detaching the front panel, be sure to press (OFF). Press (OPEN), then slide the front panel to the right side, and pull out the left side.

4

-B

��
�������軸

���示������ ������左��

4-B

To attach

Place the hole in the front panel onto the spindle on the unit as illustrated, then push the left side in.

7