Disassembly method
<Main body> Removing the metal cover (See Fig.1)
1.Remove the three screws A attaching the metal cover on the back of the body. 2.Remove the four screws B attaching the metal cover on both sides of the body. 3.Remove the metal cover from the body by lifting the rear part of the cover. ATTENTION : Do not break the front panel tab fitted to the metal cover. Bx2 A Bx2 Fig. 1 A A Metal cover
Removing the front panel assembly (See Fig.2~5)
* Prior to performing the following procedure, remove the metal cover. 1.Remove the three screws C attaching the front panel assembly on the bottom of the body and both sides of the body. 2.Disconnect the card wire from connector CN601 on the servo control board. 3.Disconnect the 4pin wire from connector CN502 on the servo control board. 4.Disconnect the 3pin wire and 8pin wire from connector ACW1 and RCW2 on the main board. Please remove a tie band if necessary. Please fix the wire again with a tie band when assembling. 5.Release the two joints a on the lower part of the sides using a screwdriver, and remove the front panel assembly toward the front.
