|
|
|
Usuarios conectados
Actualmente hay 5855 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
6.1.2 PureFlush
Use the PureFlush function when you use the appliance for the first time. Also use the PureFlush function if you have not used the appliance for more than days: When you replace the filter, the pure water dispenser performs the Pure Flush function automatically. In this case, 10 litres of water flow out of the appliance (see chapter �Cleaning and maintenance�, section �Replacement�). B Warning: Do not drink the water that comes out of the appliance during the PureFlush procedure. 1 Switch on the pure water dispenser. Wait until the dispense button d flashes (ready to dispense - manual mode). 2 Place a container with a capacity of at least 10 litres under the pure water dispenser. 3 Press and hold the dispense button d for 4 seconds. � The PureFlush procedure starts, during which 10 litres of water come out of the appliance. � The dispense button lights up green to indicate that Pure Flush is in progress. All other indicators are off. D Note: If you want to cancel the flushing procedure while it is in progress, press the power-on button y to switch off the pure water dispenser.
7 Cleaning and maintenance
7.0.1 Cleaning the pure water dispenser
B Warning: Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. B Warning: Do not pour water over the pure water dispenser. 1 Clean the outside of the pure water dispenser regularly with a damp (not wet) cloth. 2 If you have not used the appliance for 2 days or more, perform the PureFlush procedure (see chapter �Using the appliance�, section �PureFlush�).
7.0.2 Cleaning the macro filter
1 2 3
Switch off the pure water dispenser. Turn off the water supply to the pure water dispenser. Unscrew the water inlet connector (hold it in vertical position to avoid water spillage) and pull out the macro filter.
4 5 6
Rinse the macro filter under a running tap. Remove the dirt from the mesh. Put the macro filter back in its original position. Reattach the water inlet connector.
1
|
|
|
> |
|
