AEG WM 1000 A
Manual de Usuario

Clean carefully under a fast running tap.

The dangers of freezing
If the machine is exposed to temperatures below 0°C, certain precautions should be taken. n Turn off the water taps. n Unscrew the inlet hoses. n Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hoses in a bowl. Run the draining programme . n Disconnect the appliance. n Screw the inlet hoses and reposition the drain hose.

P0040

Warning
When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it.

n

When you intend to start the machine up again, make sure that the room temperature is above 0°C.

The water inlet filters
If your water is very hard or contains traces of lime deposit, the water inlet filters may become clogged. It is therefore a good idea to clean them from time to time. Turn off the water taps. Unscrew the water inlet hoses. Remove and clean the filters using a hard bristle brush. Replace the filters and tighten up the inlet hoses.

P0041

17