BAUKNECHT WA 7575 W /WS-D
Guía de consulta rápida

GB Overview of consumption data
Programme Duration* (hour : minutes) Terminate the �Rinse Hold� option:

Programme approx.

Temperature Max. Load Water Energy Note: The programme stops to at time the �Rinse Hold� button light flashes. (°C) (kg) (l) (kWh)

Cotton 95 5.0 44** 1.60 1 : 55 � Press �Rinse Hold� button again; programme will terminate automatically with the final

Coloured Cotton 60 5.0 39 0.95 2 : 00 spin cycle for the present wash programme.

Coloured Cotton 40 5.0 39 0.55 1 : 45 � If you do not wish spin clothes, turn selector knob to the drain programme

Coloured Cotton + Rapid 30 3.0 32 0.40 0 : 50 and press the �Start/Pause� button again.

Programme 3.0 35 0.40 0 : 30

�Spin Speed Reduction� button Synthetics 60 2.5 55 0.70 1 : 30 � Every programme has an automatic predefined maximum spin speed. Synthetics 40 2.5 50 0.50 1 : 15 � Press the button to set another spin speed. � If spin speed �0� selected, the final spinning cancelled. The water is drained out only.

Delicates 30 1.5 50 0.50 0 : 45 START DELAY

Wool 1.0 50 0.50 0 : 40

Handwash cold 1.0 0.20 0 : 35

The �Start Delay� allows to run machine the consumer�s convenience, for example at night when electricity is cheaper.

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in � Press �Start Delay� button select the delay time by 1 to 19 hours; normalized conditions in compliance with Standard IEC 60 456. The data on the �Energy Label� refer to programme � Press �Start/Pause� button. The �Start Delay� light flashes until the programme starts. �Coloured Cotton 60 °C�. Consumption data home may vary with respect values the table in relation to � The time delay indication disappears when programme starts and it�s replaced by the water supply pressure temperature, load and the type of wash.

� The number of hours preselected can later be reduced pressing again the �Start Delay� button. the household conditions applicable at that time.

remaining time. * The remaining time indicator can similarly deviate from values in the table, because it takes into account

** reduce temperature, some cold water is added at end of main wash cycle, before To cancel the �Start Delay�.

ADD DETERGENT, CLOSE DOOR AND SELECT THE PROGRAMME � Reselect desired programme options and press the �Start/Pause� button. PROGRAMME START Add detergent as described chapter �Detergent and Additives� in the booklet.
�Start/Pause� Open tap and press button. The pilot lamp of the button lights up. The indicator lamps show sequence reached in programme. After starting the programme, indication runs from left to right through Wash, Rinse, Spin. When sequence of the programme is finished the corresponding lamp goes out.

pump drains the water out. � Turn programme selector to the � � position.

1. Turn selector knob to the desired programme and temperature. � The remaining time display shows duration of the chosen programme (in hours and minutes)

and pilot lamp of the �Start/Pause� button is flashing.

2. The programme sequence and predefined spin speed indication corresponding to the

selected programme lights up.

PRESS ANY DESIRED OPTION BUTTON(S). The pilot lamp lights up.
During first 15 minutes of cotton and synthetics programmes the door can be opened for adding further laundry. This not possible if �Rapid Wash� is selected. The door can be opened when the �Door Free� indication is shining.

DOOR LOCK

An audible tone sounds if the combination of programme, additional options and temperature is not possible. Unsuitable combinations of options are deselected automatically. �Eco Wash� button

PROGRAMME END � The duration wash is extended and the temperature reduced save up to 40% of energy
� The remaining time is on �0:00� and all lights of the programme sequence indication are off. maintaining good washing results. A short audible tone sounds three times. �Rapid Wash� button

� For quick, economical washes. Ideal for minimum loads of lightly-soiled articles. 1. Turn programme selector to the � � position. �Prewash� button 2. Turn the water supply tap off. � Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases 3. Open door and unload the machine. by approximately 15 min. CHANGE THE AND OPTIONS AFTER PROGRAMME START �Intensive Rinse� button 1. Press �Start/Pause� button to pause the programme. The light flashes. � A further rinse cycle is added. 2. Select the new programme, any options and another spin speed if you want it. � This option is particularly suitable for areas with very soft water washing baby linen and helps 3. Press �Start/Pause� button again. The new programme continues at the same position where people with allergies. the previous programme was interrupted. Do not add detergent for this programme. �Rinse Hold� button � The laundry remains in last rinse water without progressing the final spin cycle to avoid 1. Press �Start/Pause� button to pause the programme. The light flashes. creasing and prevent colours from changing. 2. Set programme selector to �Drain�. The spin indicators show �0� and the remaining time � This option is particularly recommended for the programme �Synthetics� or �Delicates�. 3. Press �Start/Pause� button to start the drain programme.

TO CANCEL A PROGRAMME BEFORE THE END
shows 2 minutes. � This function is particularly useful if you want postpone spinning to a later time.