WHIRLPOOL W246
Manual de Usuario

Oven

Racks

and Rack

Supports

Oven lacks: To remove, pull forward to the "stop" position; lift up on the front of the rack and pull out. (h'en Rack Supper/s: To remove, lift support holders from slots at the front of the oven then move supports away from oven wall. Pull forward to remove from oven. To replace, reverse procedure. Be sure front supports are correctly in place so that racks will be level.

Oven

Thermostat

Knob

Adjustment

The oven thermostat knob can be adjusted if the oven temperature is too low or too high and the length of time to cook ALL foods is too long or too short. Do NOT adjust the thermostat knob if only one or two items are not baking properly. To adjust the thermostat IkJN_l): _Triangle _'__.._,/"_._ // _'_s_c __ _ o _,..--TopScrew " '_'_ o o ))_ /� / Skirt

Turn the the knobthermostat itknobthetounderRemove oven and turn to OFF. nea th side. Ho ld it so that the tri ang le is at the top. (See Fig. 1) Loosen in the two screws slightly. Holding the skirt place, move the noted by one click, topscrewbyrotating in theknobonenoteh, direction necessary. as If notch indentation is not apparent, tighten screwsuntilclickingisheard. notches in each direction. approximately 10° F. EXAMPLE: Zherearefive One notch equals is too

/Q __ _

_(_i_)_.. _ -""""'_ ,-¢

FIG. 1

If the oven temperature

a longer time period to cook, the knob should be rotated to move the top screw toward the word "HOTTER". (See Fig. 2) Tighten the screws while tightly holding knob to skirt. To replace knob, match flat part of knob opening with springrequiring cool and ALL foods are on the shaft, returning to OFF position. _ , _o_c _Q_ H o___ie j.._ _ __ -_"_% :.,_._ _"

_

/ FIG. 2

IMPORTANT: The oven thermostat knob should be adjusted one notch and then the oven should be tested. (We recommend baking 2 -- 9" yellow layer cakes using a purchased box mix.) If the oven temperature is still too low or too high, repeat the procedure described above. If the knob is rotated too far or in the wrong direction, rotate the knob in the opposite direction until the center of the screw is directly under the triangle, which is the starting point. Initiate the procedure again until the desired temperature is reached. 27