RICOH VT2200
Manual de Usuario

1 November 1996

MASTER FEED SECTION

4. MASTER FEED SECTION
4.1 THERMAL HEAD VOLTAGE ADJUSTMENT
Purpose: To maintain master making quality and extend the lifetime of the thermal head. NOTE: This adjustment is always required when the thermal head or power supply board is replaced.

[B]

[A]

1. Remove the rear cover and the right cover of the machine. 2. Disconnect the connector [A] from the plotter unit. 3. Check the voltage noted on the decal located on the thermal head. (The voltage is different for each thermal head.) 4. Access "I/O Check Mode". � SP mode No. 131, then Output Check mode 41. 5. Press the Start key to apply the thermal head voltage. 6. Confirm that the voltage between one of the VHD terminals and one of the ground terminals of CN503 is at the level specified on the decal (Within + 0 V, � 0.1 V). 7. If it is not, adjust VR1 [B] on the power supply board. NOTE: Press the Stop key to stop applying the thermal head voltage. Do not keep the thermal head voltage on for a long period.
Replacement Adjustment

5-15