PIONEER VSX-D309/KCXJI
Manual de Servicio

VSX-D409, VSX-D309

8. PANEL FACILITIES AND SPECIFICATIONS
8.1 PANEL FACILITIES

Front Panel 1 23 4 56
N�m-��?/

The illustration shows VSX-D309.

7
Digital Signal Processor

8 9 0-

=
1
R

MPX MODE

2/DTS

SIGNAL SELECT

PHONES

MIDNIGHT

@

@

~
1 STANDBY indicator

!

@

#

$%

^

&

0 2 /DTS button
Use to switch between the various Dolby/DTS surround modes.

Lights when the receiver is in standby mode (note that the receiver consumes a small amount of power (1W) in standby mode).

- SIGNAL SELECT button
Use to select between an analog or digital signal.

2

STANDBY/ON button
Switches the receiver between on and standby.(note that the receiver consumes a small amount of power (1W) in standby mode).

= MASTER VOLUME
Use to set the overall listening volume.

3 STATION (+/�), FREQUENCY (+/�), TUNING SELECT buttons
STATION (+/�) Selects station memories when using the tuner. FREQUENCY (+/�) Selects the frequency when using the tuner. TUNING SELECT Switches between station memory and frequency select modes.

~ PHONES jack
Use to connect headphones but this does not switch the speakers off.

! SPEAKER button
Use to switch the speaker system on or off.

@ DIRECT button
Use to switch DIRECT playback on or off. This mode bypasses the tone controls and channel levels for the most accurate reproduction of a program source.

4 CLASS button
Switches between the three banks (classes) of station memories.

# BASS (+/�) buttons
Use to increase/decrease bass (within a range of 6dB in 2dB steps). -6dB to

5 MEMORY button
Press to memorize a station for recall using the STATION (+/�) buttons.

$ TREBLE (+/�) buttons
Use to increase/decrease treble (within a range of 6dB in 2dB steps). -6dB to

6 MPX button
lf the TUNED or STEREO indicators don't light when tuning to an FM station because the signal is weak, press the MPX button to switch the receiver into mono reception mode. This should improve the sound quality and allow you to enjoy the broadcast.

% Function buttons
Use to select a source for playback or recording.

^ MIDNIGHT button
Use when listening to movie soundtracks at low volume. This feature will enable you to hear quiet sounds and not get jolted by loud or sudden sound effects.

7 Display 8 Remote sensor
Receives the signals from the remote control.

& FL DIMMER button (VSX-D309)
Use this button to make the fluorescent display (FL) dimmer or brighter. There are three brightness settings as well as an off setting.

9 DSP MODE button
Use to switch between the various DSP modes available (HALL1, HALL 2, JAZZ, DANCE, THEATER1, THEATER 2) and DSP off. Use to create different surround sound effects from any stereo source.

MONITOR button (VSX-D409)
Press to switch tape monitoring on/off.

56