|
No hay comentarios de productos.
02
5 minute guide
Using the Quick Setup
You can use the Quick Setup to get your system up and running with just a few button presses. The receiver automatically makes the necessary settings after you have selected your speaker setup, room size and listening position. Use the front panel controls for the steps below. � If you want a more complete setup option, refer to Automatically setting up for surround sound (MCACC) on page 11. If you choose to do so, you can skip the Quick Setup.
� Check the table below to find the speaker setup that corresponds with your system.
1
If the receiver is off, press STANDBY/ON to turn the power on.
2 Press QUICK SETUP. SW DET flashes in the display while the receiver checks your setup for a subwoofer. SW YES or SW NO confirms the subwoofer
check, then the display prompts you to select your speaker setup.
4
Press ENTER.
3
Use the MULTI JOG dial to choose your
speaker setup. When a subwoofer was detected in step 2, you can cycle between the following choices:
5 Use the MULTI JOG dial to choose your room size. Depending on the distance of your speakers from the listening position, choose between small, medium, or large (S, M or L), M being an average-sized room. 6 Press ENTER.
2.1ch 7.1ch 6.1ch
3.1ch 4.1ch 5.1ch
7 Use the MULTI JOG dial to choose your listening position. You can cycle between the following choices:
� FWD � If you are nearer to the front speakers than the surround speakers � MID � If you are equal distance from the front and surround speakers � BACK � If you are nearer to the surround speakers than the front speakers
If a subwoofer wasn�t detected in step 2, you can cycle between the following choices:
2.0ch 7.0ch 6.0ch
3.0ch 4.0ch 5.0ch
8 Press ENTER to confirm your setup. The display shows the speaker setup, room size and listening position that you have selected.
10
En
|
