In case of difficulty Tuner
Symptom Radio stations cannot be received. Cause � No antenna is connected. � The broadcast band is not set properly. � The frequency of the desired station is not tuned. � Noise due to ignition noise from an automobile. � Noise due to interference from an electric appliance. � Noise due to a nearby TV set. A station which was preset cannot be received by pressing the corresponding numeric key. � The preset station belongs to a frequency that cannot be received. � The preset memory was cleared because the power cord had been unplugged for a long period of time. Remedy � Connect an antenna. ( � Set the broadcast band properly. � Tune the frequency of the desired station. � � Install the outdoor antenna away from the road. � Turn off the power to the appliance. � Install the receiver farther away from the TV. � Preset a station with a receivable frequency. � Preset the station again.
Interference.
Remote control unit
Symptom Certain inputs cannot be selected using the remote control. Remote control operation is not possible. Cause � No setup codes registered for the respective input(s). � The remote control unit is set to a different operation mode. � Batteries are exhausted. � The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle between the receiver and the remote. � No disc or tape is placed in the source component. � An attempt is made to play a tape which is being recorded in the cassette deck. � The remote control has not been set to the operation mode for the component you wish to control. Remedy � Register a setup code at the respective input(s). w � Press the RCV MODE key to select the appropriate operation mode. � Replace with new batteries. � Operate the remote control unit within the controllable range.
� Place the disc or tape in the source component which you want to play. � Wait until recording has completed. � Press any of the Source keys or SOURCE key to activate the operation mode for the component you want to control before operation. w
