NIKON VAA12201
Manual de Servicio

INC
VAA12201-R.3581.A

14. SB UNIT
� Attach the SB flash unit � Pass the red and white wires of the main condenser through the space between the pillar A and the wall of the joint unit. �ref. Fig.1� � Put the yellow wire of the trigger around the outside of the pillar A, and assemble the flash unit. �ref. Fig.2� � Attach 2 screws (#802). Note�In case of using a tweezer when arranging each wire (red, white and yellow) of the SB unit, be careful not to damage the cable sheath. �If using a sharp-edged tweezer, cover it with the constriction tube, etc. )

Pillar A of the joint unit

White �Red

Arrangement of red and white wires Fig.1

#802�2
Yellow

SB flash unit

Pillar A

Put the yellow wire around the outside of the pillar A Fig.2

�Attach the red and white wires of the main condenser to the both-sided adhesive tape that is attached on the lens-barrel. �ref. Fig.3� Both-sided adhesive tape
(#567)

�Note�Do not slacken the red and white wires, and do not allow them to put on the corner of the joint unit.

Corner of the joint unit Fig.3

- A17 ï½¥ SQ -